Zubax/canface_cf2

Issues

• Improve/Fix LED colors, correct text on top plate

  #46 opened 5 months ago by maksimdrachov
  3

• add hole on the upper left corner of the enclosure PCB

  #45 opened a year ago by Zentrus
  0

• Flip the Babel reset switches

  #43 opened a year ago by pavel-kirienko
  0

• add Zubax logo to the enclosure PCB

  #38 opened a year ago by Zentrus
  0

• ERC Warnings & Part Number Check

  #35 opened 2 years ago by Zentrus
  1

• Copy relevant chapters from the Zubax Babel datasheet

  #27 opened 2 years ago by pavel-kirienko
  0

• Add reset button for DCP

  #31 opened 2 years ago by pavel-kirienko
  0

• Updating the DroneCode Probe firmware should not require diassembling the device

  #30 opened 2 years ago by pavel-kirienko
  0

• CAN bus voltage measurement

  #29 opened 2 years ago by suzonch
  0

• CAN_VDD_EN not pulled up to 5v

  #28 opened 2 years ago by suzonch
  0

• DCP enters the bootloader mode at first power on

  #9 opened 2 years ago by pavel-kirienko
  14

• Fix USB footprint

  #19 opened 3 years ago by farzan-saleem
  0

• Babel switch label is on wrong side

  #16 opened 3 years ago by farzan-saleem
  0

• Eliminate unnecessary assembly variants

  #13 opened 3 years ago by pavel-kirienko
  2

• The blow scheme provided in the manufacturing doc is incorrect

  #14 opened 3 years ago by pavel-kirienko
  2

• Add the window for the LEDs in DCP part in the top panel.

  #8 opened 3 years ago by j3qq4hch
  0

• Error in TPD3S014 EN pin control in Babel section

  #6 opened 3 years ago by j3qq4hch
  0

• Vref pin unrouted

  #10 opened 3 years ago by farzan-saleem
  0

• Invalid blow scheme in manufacturing readme.

  #5 opened 4 years ago by j3qq4hch
  0