copterust/mpu9250

Issues

• Timing issue in configuration.

  #9 opened 6 years ago by nraynaud
  10

• Freeze on initialization of DMP on MPU-6500

  #43 opened a year ago by justacec
  0

• Support I2C master mode (bypass disabled)

  #41 opened a year ago by pkb-pmj
  1

• Support different I2C addresses

  #40 opened a year ago by pkb-pmj
  6

• the trait bound `u16: cast::From<_>` is not satisfied

  #39 opened a year ago by mwbryant
  3

• How to pass mpu9250 handle to a function

  #37 opened a year ago by liebman
  2

• Running example/rpi.rs on raspberry pi zero multiple times causes program to hang indefinitely.

  #29 opened 4 years ago by MechanicalPython
  11

• SpiError and I2CError are private

  #35 opened 4 years ago by pftbest
  0

• How to read measurements triggered by interrupt pin?

  #34 opened 4 years ago by pftbest
  2

• Get/set biases for both mpu and dmp

  #32 opened 4 years ago by mariusknaust
  3

• More then one package in the FIFO causes DmpDataInvalid error

  #25 opened 4 years ago by mariusknaust
  0

• DMP load_firmware fails

  #22 opened 4 years ago by mariusknaust
  5

• Builder Pattern for MpuConfig

  #20 opened 5 years ago by tchamelot
  3

• Add maintainer

  #23 opened 4 years ago by tchamelot
  1

• Support for Digital Motion Processor

  #18 opened 4 years ago by tchamelot
  1

• Infinite loop in AK8963::write

  #21 opened 4 years ago by mariusknaust
  1

• With after pulls/#11 `mpu.all()` transaction taking 10ns on my device

  #12 opened 5 years ago by little-arhat
  4

• Support UART

  #16 opened 5 years ago by lorenzleutgeb
  3

• Advantages/Disadvantages of I2C (vs SPI)

  #15 opened 5 years ago by michael-p
  6

• Documentation states that mag values are in tesla, is this correct?

  #14 opened 5 years ago by pftbest
  4

• Allow for 20MHz SPI

  #6 opened 6 years ago by nraynaud
  9

• Calling mpu.calibrate_at_rest() results in blank mag readings

  #10 opened 6 years ago by jamwaffles
  3

• Support for more MPU devices

  #4 opened 6 years ago by fmckeogh
  3

• Mpu9250's explicit type can't be written.

  #3 opened 6 years ago by nraynaud
  1

• Mpu9250::marg crashes on mpu6500

  #1 opened 6 years ago by little-arhat
  0