Issues
- 2
Preview not loeading on JLCPCB
#86 opened by adnanaq - 4
- 16
[Sweep v2] Peripheral side not sending inputs
#55 opened by rodrigocam - 1
Sweep half-swept halves are not communicating
#82 opened by cfshe - 3
any interest in a diodes sweep?
#73 opened by idank - 1
Short at TRRS jack
#78 opened by cgahr - 1
Sweep v2.2 Schematic Wrong?
#75 opened by Allstreamer - 1
Sweep High M variant has silkscreen on the microcontroller contacts preventing soldering
#81 opened by eallenwright - 0
- 4
Question: Switch compatability
#79 opened by SolninjaA - 3
No Input registered when plugged in on Boot
#77 opened by eXq2lt - 1
Is there any top plate for the sweep LP?
#76 opened by jittapont - 3
- 2
- 1
- 8
[Custom Sweep v2]: Keys not registering
#69 opened by Sheape - 2
- 2
Where to source batteries?
#68 opened by JezThePhilo - 10
- 3
- 4
- 2
Question: Why are the switch holes and solder pads on the Sweep Bling MX rotated upside-down
#64 opened by smoky19x - 5
Feature request: Battery JST connector
#63 opened by shrekale - 1
- 4
Is the nRFMicro compatible with Sweep?
#61 opened by conceptroot - 1
- 0
- 1
[Sweep v2] Too many slots / Extra drill time fee
#58 opened by muk343 - 2
Sweep Compact Low (additional keys)
#56 opened by zaddok - 7
Which is the behaviour of the on/off switch?
#43 opened by leiserfg - 3
- 3
Reset button for the compact low version
#47 opened by riveraletelier - 1
- 3
Feature request: hot swap socket support
#34 opened by dlip - 2
PJ-320A alternative wiring
#50 opened by sommerper - 4
Sweep High Plated Slot Width
#48 opened by ballin2much - 4
[Sweep High] Overlaps in edge cuts layer
#40 opened by John-Ingram - 2
Sweep2 vs Sweep Bling MX
#45 opened by p0da - 2
[Bling Mx] Artifact left on bottom plate
#44 opened by zachatttack - 1
Support for BlackPill (STM32F4X1)
#41 opened by matru - 2
Top Plate Generation for Sweep High
#37 opened by ThePreviousOne - 2
JLCPCB says "Panel by Customer" for Sweep 2.1
#35 opened by lzhang10 - 2
3D printable top plate for the Sweep High?
#32 opened by mrtnee - 2
there is missing components.
#36 opened by partrita - 3
miryoku keymap
#33 opened by rnyPlanet - 1
- 2
Sweep High Half-Swept
#25 opened by hadaad - 1
Reset switch part #
#28 opened by Cheffromspace - 4
Question: Difference between High and High M
#30 opened by isavcic - 0