Sevenstax/FreeV2G

Issues

• Question: There is a discrepancy with the documentation. What is the problem?

  #345 opened 3 months ago by Volodymyr233
  2

• Question: How to handle certificates for Plug and Charge ?

  #344 opened 3 months ago by DeividasPalu
  1

• Question: what is the proper way to end a charge session?

  #342 opened 3 months ago by pxidr
  6

• Using WHITE Beet with a network switch

  #343 opened 3 months ago by pbekandeatador
  1

• Cable check not receive from citroen ec3 Car

  #340 opened 3 months ago by nikunjp26
  16

• Question:So what is the UART Debug exchange rate?

  #341 opened 3 months ago by Volodymyr233
  2

• Question: Firmware Update Problems

  #335 opened 4 months ago by DeividasPalu
  8

• Question: Codico Whitebeet 1.1 Ethernet - How to Permanently Disable Interface?

  #338 opened 4 months ago by brunesi
  5

• Sequence error getting in XUV 3XO car of Mahindra

  #319 opened 6 months ago by nikunjp26
  9

• Charging session not working when PEV is requesting secured connection, but WHITE Beet EVSE does not offer it.

  #291 opened 9 months ago by Ivangel1972
  48

• Session hanging after SLAC

  #337 opened 4 months ago by giguerator
  7

• RX_READY, TX_PENDING, SPI issue

  #331 opened 4 months ago by kunalcha63
  9

• Spi Data Exchange frame Identifier error after some time

  #322 opened 4 months ago by xuanlanghuang
  10

• EV - FW V01_00_07 - Port mirroring - CM_ATTEN_CHAR.IND not forwarded when using network switch

  #334 opened 4 months ago by giguerator
  4

• Getting Unexpected Sub ID while testing EVSE and EV simulator with V2.1.0 firmware

  #333 opened 4 months ago by jptalledo10
  10

• Charging CUPRA leads to sequence error // skipped cable check from CUPRA?

  #314 opened 5 months ago by fjdicker
  7

• Getting "waiting for energy transfer mode selection" error.

  #326 opened 5 months ago by nikunjp26
  5

• Session still stopped after ServiceDetailReq

  #332 opened 5 months ago by Kristanpivk123
  3

• Bus Transaction is interrupted at 55 percentage

  #318 opened 5 months ago by nikunjp26
  15

• Session was not going into charging state

  #323 opened 5 months ago by nikunjp26
  7

• cable check not receive

  #327 opened 5 months ago by nikunjp26
  3

• SPI_TX_PENDING is always high 3,3V

  #330 opened 5 months ago by AdrianKn
  4

• Question: The SPI_TX_PENDING is permanently high (3.3V)

  #329 opened 5 months ago by AdrianKn
  1

• Question: Steps to Update the firmware of WhiteBeet Module

  #302 opened 6 months ago by varshilgandhi
  16

• python-libpcap dependency installation on Linux 6.1.22 Platform

  #321 opened 6 months ago by KrushanPatel
  4

• Session stop after SDP response

  #328 opened 6 months ago by vsCodeGB
  1

• Question: How can I set the IPV6 address on the EVSE board.

  #325 opened 6 months ago by Rajdipsinh15
  7

• Question: How can I Set the IPv6 address

  #324 opened 6 months ago by Rajdipsinh15
  1

• Question: how can I (EV) know that Cable Chack had failed?

  #317 opened 6 months ago by Kristanpivk123
  2

• Question: Plans to add VAS - internet access

  #315 opened 7 months ago by Dalachowsky
  3

• Question: SPI communication failure due to re-sync

  #296 opened 6 months ago by FivaTagin
  10

• issue on Send Stop charging using DIN

  #309 opened 7 months ago by LeeoMariani
  12

• Stop Charging Issue with SEVENSTAX V2G EV Simulator V2G EV V01.01.04 for DC EV Charger

  #316 opened 7 months ago by Anita-mahale
  1

• We have to restart PLC modem before every session.

  #308 opened 7 months ago by sametyazici
  11

• Why does the White Beet board communicate with controller in EVSE mode but not in EV mode using FreeV2G??

  #297 opened 7 months ago by Hipowerguy
  17

• Discordance between EV and EVSE target current parameter

  #313 opened 7 months ago by Hipowerguy
  2

• Question: What to do with SLAC Matching Fail

  #301 opened 7 months ago by xuanlanghuang
  4

• Session stopped event right after sending Start Charging.

  #311 opened 7 months ago by vsCodeGB
  2

• Question: Wireshark doesn't show bridged EV messages

  #310 opened 7 months ago by Zaghz
  2

• Status Message Schedules Requested

  #299 opened 7 months ago by fjdicker
  6

• Question: ReSync from SPI communication Error

  #295 opened 7 months ago by xuanlanghuang
  6

• Question: WB PS 1.1 Module: Ethernet connection without Phy possible?

  #307 opened 8 months ago by andrelmk
  1

• Rules of Conduct

  #303 opened 8 months ago by lho-stx
  0

• PLEASE READ BEFORE POSTING

  #304 opened 8 months ago by nststx
  0

• Error: Did not receive frames after "DC Charge Parameters Changed Received"

  #300 opened 8 months ago by varshilgandhi
  9

• Question: How can I change the IPv6 address

  #293 opened 8 months ago by fjdicker
  4

• Charging session continues when disconnecting CP lines

  #290 opened 8 months ago by varshilgandhi
  25

• Looking for a collaborator who has a working version of White Beet ESVE system

  #298 opened 8 months ago by Hipowerguy
  1

• Response code 0x10 for PI1.1

  #294 opened 9 months ago by ahpo2019
  1

• SLAC process timeout, no CM_SLAC_MATCH.CNF received.

  #292 opened 9 months ago by MihaiBadescu
  1