Can't get in to the menu (Raceflight Millivolt v1)
artemaminov opened this issue · 3 comments
THR MID + YAW RIGHT + PITCH FULL (UP)
Voltage and Arm status are correct
FC Version - 1.2.94.193 Stabel
FC Hardware - Flight One Revolt (Millivolt v1)
MWOSD 1.9.1.4 FW
Millivolt UART3 TX->RX and RX->TX connected to micro minimosd
set set telem_msp=3
Hi,
To enter menu the following need to be correct.
Disarmed
Pitch > 1850
Yaw > 1850
Throttle < 1150
They also need to be received in correct order from the flight controller. I am not sure how well Flight one follows the MSP protocol.
To verify,
Flash 1.9.1.4, utilities, debug, msp115k
On screen RC values received will be shown and first four shoul dbe in order
Roll,
Pitch,
Yaw,
Throttle.
You can see if values are received, order is correct and meet the criteria to access menu.
No RC data coming. Millivolt v1 is not supported?
Hi I suspect FlightOne is not sending the data. Thought that might be the case actually. I have had a look at their documentation and it doesnt say much about MSP serial. Recommend raising it on their support forums as a request.