Battery Connector Polarity is Labeled Incorrectly on PCB
abrahamjsimpson opened this issue · 2 comments
abrahamjsimpson commented
We are using version 2.6. Looking at the PCB design (board.brd), I noticed that between the connector where the battery is plugged in and the header for the left encoder there is silkscreen text (on layer 25, tNames) that says "VCC GND" (see screenshot).
It seems that this label is intended for the battery connector; however, if so, they are reversed! As the screenshot shows, ground is actually on the left and VCC is on the right. This should be fixed.
rezeck commented
Hey @abrahamjsimpson,
Thank you for reporting this issue.
I incorporated this modification in the 2.7 version of the board.
Best,
Rezeck
abrahamjsimpson commented
Thank you!